Strike F1 to retry reboot, F2 for setup utility. Before you begin any of the procedures in this section, follow the safety instructions in your Owner’s Manual. The system configuration information in the system setup program is incorrect or the battery charge may be low. Memory modules are detected, but a memory failure has occurred. The operating system cannot be located on drive A or drive C. Determine if a conflict exists by removing a card not the video card and then restarting the computer. Master DMA register failure.
|Date Added:||4 February 2008|
|File Size:||59.48 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
If dlmension hear one of the following beep codes, see “Contacting Dell” in your Owner’s Manual for instructions on obtaining technical assistance. Enter the system setup programverify the system configuration, and then restart the computer. A possible floppy or hard drive failure has occurred. If the problem persists, you may need to replace the keyboard.
Your computer might emit a series of beeps during start-up if the monitor cannot display errors or problems. Continue until you have identified a faulty connector or reinstalled all modules without error. Memory not being properly identified or used. Video Memory Test failure. Memory modules are detected, but a memory configuration or compatibility error exists. The BIOS cannot communicate with the floppy drive or hard drive controller.
Verify that the computer is plugged into a working electrical outlet and that you have pressed the power button.
If the problem persists, see “Contacting Dell” in your Owner’s Manual for instructions on obtaining technical assistance. The system configuration information in the system setup program is incorrect or the battery charge may be low. Repeat this process for each card.
Dell Dimension C Specs – CNET
Ensure that nothing is resting on the keyboard; if a key appears to be stuck, carefully pry it vieo. An error occurred with the keyboard connector. To help you troubleshoot a problem, your computer is equipped with four lights on the back panel labeled “A,” “B,” “C,” and “D. A possible video card failure has occurred. Ensure that the cables are properly connected from the hard drive, CD drive, and DVD drive to the system board.
Serial or parallel port test failure. If the computer has a video card, remove the card and reinstall itand restart the computer. Reseat all power and data cables and restart the computer. If you have one memory module installed, reinstall it and restart the computer.
Memory failure above address 0FFFFh. An error in the address decoding circuitry in the memory has occurred.
Strike F1 to retry reboot, F2 for setup utility. If the problem still exists, install a video card that you know works and restart the computer.
After the computer starts, the lights remain green. Ensure that the drive is installed correctly in dimenslon computer and defined correctly in the system setup program.
Determine if a conflict exists by removing a card and then restarting the computer. See “Contacting Dell” in your Owner’s Manual for instructions on obtaining technical assistance. Keyboard Controller Test failure. Search for video ROM failure.
Slave DMA register failure. Reseat the memory modules.
The operating system cannot dimmension located on drive A or drive C. To eliminate the possibility of a faulty memory connector, remove all memory modulesreinstall one memory module if the computer supports a single moduleand then restart the computer.