Join our community today! Please type your message and try again. Far slower than 10mbit. Is this my only option? Last edited by silmaril8n; at The Connection Failed Test Details: Go to original post.
|Date Added:||27 November 2014|
|File Size:||29.16 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
IntelR 82567LM-3 Gigabit Network Connection Driver
Seemed to be a hardware problem or maybe some firmware got changed with the board. Go to original post. Page 1 of 2.
At any rate, I’ll set neteork back. When I edited the conf again and rebooted, the output during bootup looks like the same, but the address is held and I’m effectively online.
To continue using , please upgrade your browser.
Something is screwy there. Are you new to LinuxQuestions.
After that it worked perfectly. Slackware This Forum is for the discussion of Slackware Linux.
Introduction to Linux – A Hands on Guide This guide was created as an overview of the Linux Operating System, geared toward new users as an exploration tour and getting started guide, with exercises at the end of each chapter. What is the ethernet cable plugged into?
Downloads for Intel® 82567 Gigabit Ethernet Controller
If none are present on the server the test can not be run. Out of curiosity, which router do you have?
Couldn’t find a package, but the source will do. I’m a newbie so pls bear with me. You may want to check you gateway router’s configuration http: Keep the MTU at Netgear-FVS The latest firmware is 3.
MTU set to dhcpcd: Note that registered members see fewer ads, and ContentLink is completely disabled once you log in. By trial and error I have found out that the connection works when set to 10mbit full duplex.
HP said to backup my data and restore the system. Open Source Consulting Domain Registration. Registration is quick, simple and absolutely free.
I think I’ll still update dhcpcd to 5. Got wicd installed and wireless came right up, nvidia drivers installed and video is fantastic, but for some reason my wired connection isn’t happening. The link partner is not capable of higher speeds. The time now is I had a similar problem after upgrading the kernel to 2.