|Date Added:||19 March 2007|
|File Size:||18.44 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Test times will also be improved in a system where the supply is switched and the power supply is set to zero before the supply is switched.
This data sheet contains agilnt, general characteristics, and other related information for the Keysight A, A, A, A and A DC power supplies, and all the Series special option power supplies.
Calibration Certificates Criteria have been established to determine which products get or do not get a calibration from the factory. Legal Privacy Terms Trademark Acknowledgements. Legal Privacy Terms Trademark Acknowledgements. Peak-to-peak noise is measured from the maximum positive point on the waveform to 66xa most negative voltage point.
Poorly designed linears can have commutating spikes when their bridge rectifier diodes turn off. Remote Inhibit FAQ The power supply should be programmed to 0V before its output relay is opened or the power supply is reset.
Since a magnet is basically a large inductor, the power supply must be stable when driving a large inductive load. An example is testing an automotive component at a high voltage 14V, a nominal voltage of 12 V and a low voltage of 10V.
Ca Keysight power supplies sink current?
Active loads that create a sinking current should not be connected to a power supply. When you’re trying to boost throughput in time-critical production test systems, a small change in the way you operate or program a supply can have a surprising impact on test speeds. Contact an Expert Chat Live. Programmable Current Sinking In general, current sinking is a fixed value at some percentage of the full scale current output.
66xxA and 68xxB: Remote Inhibit | Keysight (formerly Agilent’s Electronic Measurement)
Sinking 66xa provided to improve a power supply’s transition time from a higher to a lower constant voltage level, and is not intended to be a steady-state operating condition. Related Links Table of switching vs. Test times in which a DUT is tested at several output voltages will be improved. Criteria have been established to determine which products get or do not get a calibration from the factory.
What is down programming?
Legal Privacy Terms Trademark Acknowledgements. The resultant voltage for series connections cannot exceed the maximum floating voltage allowed for any on the component power supplies. On the xB series, the maximum negative current tracks the value programme See search results instead: A product with a product number does not automatically qualify for a calibration certificate.
However, many switching supplies are still available from other manufacturers that do not offer this level of performance. The 5kW series offers peak-peak noise as low as 10 mV and output programming response times as low as 9 ms. Learn ten simple ways to improve your testing capabilities with your power supplies and electronic loads. This makes choosing the correct line voltage option more challenging.
See search results instead: However, there is an exception for one series of Keysight power supplies.
66xxA: Power Supplies with Inductive Loads | Keysight (formerly Agilent’s Electronic Measurement)
The power supplies maximum voltage ratings may be insufficient for these applications. The “Hybrid” technology utilizes either primary or secondary 60 Hz SCR phase control switching followed by a Linear 66xxa on the DC secondary side.
The recommended calibration interv On the xB series, the maximum negative current tracks the value programme One of the popular uses of Agilent power supplies is driving large magnets. Sinking, or down-programming, is the ability to pull current into the positive terminal of power supply.
A product with a product number does wgilent automatically qualify for a calibration certificate.