BROTHER 1660E DRIVER DOWNLOAD

Yes Clean the electrode. Yes Check the motion of the paper-pick up block. Dirt on power supply terminal Failure in the charging high- voltage circuit 5 Is there any dirt on the cartridge side charging terminal of the transfer unit and on the terminal of the high-voltage power supply charging unit? A reflected beam, though invisible, can permanently damage the eyes. Now initializing MIO error if this message remains displayed.

Uploader: Fenrishura
Date Added: 21 April 2010
File Size: 63.71 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 79369
Price: Free* [*Free Regsitration Required]

Yes Clean the transfer roller and, if the dirt remains, replace the transfer roller assy. When the cooling fan stops to rotating, an over-voltage protection or a short-circuit protection function is activated, and all the DC power supplies are cutoff.

Brother HL e Toner Cartridges & Supplies

Then the residual toner is removed from the drum surface with the cleaner blade. LCDE A signal to start the operation.

Paper feed chassis unit Figure 4. The laser diode in the scanner unit generates a laser beam modulated by DATA. Since this image of negative charges on the drum is invisible to the eye, it is called an “electrostatic latent image”.

A paper jam is detected by whether the paper is present at the sensor at the check periods programmed in the engine CPU memory. No font cartridge is set.

  ACTIONTEC 56K DRIVER

In this case check and clear the cause on the load after turning the power switch SW1 off, and then switch the power on again at least one minute after the power shut-down. Printers by Rick Broida Oct 16, Jam remove cover failure 6 Is the jam remove cover deformed? This operation should be carried out with the PCB removed. Best Cyber Monday deals at Staples: Wait error a few seconds, then turn it on again.

Brother HL-1660E Toner Cartridges – TN9000 Cartridges

Do not leave an EP-ED cartridge in a car in warm or hot weather even if it is in its storage box. Photoconductive layer Base Figure 2. Yes The problem was caused by toner onesided due to too little toner remaining.

No Replace the control panel unit or the switch flat cable. Is the toner image before transfer is light?

Paper feed motor 6 Does the pick-up motor rotate? Looking for a tech gift that’s not too expensive?

The printer accomplishes transfer by using the charging roller method. Areas on the drum with no charge form the electrostatic latent image.

In this case a paper jam is noticed to the external devise by a status signal. The outer layer of the drum consists of an organic photoconductor OPC ; the base is aluminum. Paper front guide Separation pad brothr Is the paper front guide broken? This fuses the toner particles to the paper to make a permanent image. No 160e the main PCB assy, the switch flat cable or the control panel unit. The transfer charging roller is thus cleaned. Yes Clean the fixing unit inlet guide.

  DESKJET 5440 SERIES DRIVER

Primary charge J Paper path Direction of drum rotation brothet mem’ op Developing stage Drum cleaning stage ] 7. The user, therefore, should be fully informed about the correct storage and handling of EP-ED cartridges. Before releasing the 4 hooks, remove the paper tray. Print paper 2 Is a recommended type of paper being used?

Paper failure 3 Does print quality improve when recommended paper is used? The path of the beam coming through the focusing lenses is reflected by the reflective mirror.